Jetty Accelerated Firmware

Title Jetty Accelerated Firmware

"Request: If you use this firmware, please take the time to click on "I Made One" with a picture of your bot.
This firmware took approx 2 months to write / test. Because this isn't something printable, the best appreciation you can show for this work is to encourage others to use it by keeping it on the Thingiverse front page. Thanks to those who have done this already. This Motherboard firmware upgrade enables acceleration with GCode support. No LCD interface required. Supports: ThingOMatic, Cupcake, Reprap and Others. Video showing an acceleration comparison:* NEW * Firmware Manual: This firmware contains many new features, some of which are: acceleration, mood light and buzzer support.Feature Changes: (Version 3.2 - 02/28/12): Any updates will be placed here, so check back often.Note: This is not an official Makerbot firmware release."

Source Thingiverse  :
Status Work In Progress
License Creative Commons Attribution-NonCommercial-ShareAlike
Development Type
Registered 6 years ago by garyhodgson
Updated 6 years ago
Author jetty

Are you sure you wish to delete development 191001?