Modified x belt mount for Prusa to increase build height

Title Modified x belt mount for Prusa to increase build height
Description

"Since I use a direct drive extruder, the x carriage belt was hitting the frame before anything else limiting the z below 100 mm. To avoid this, I installed the idler bearing inside the x idler end and designed a new belt clamp. This allowed me to go as high as 120 mm."

Source Thingiverse  :  http://www.thingiverse.com/thing:21242
Status Working
License Creative Commons Attribution
Development Type Part
Categories Printer
Goals Size
Tags Prusa
Project/Vendor RepRap
Registered 6 years ago by garyhodgson
Updated 6 years ago
Author brnrd

Are you sure you wish to delete development 231001?