Accessible Wade's Extruder

Superseded by Greg's Hinged Accessible Extruder.
Title Accessible Wade's Extruder
Description

This is an extruder based strongly on the wades from the Prusa git repo. It has several features over the standard wade: + Accessible hobbing + The motor can be removed without removing the large gear. + Slightly higher gear ratio than standard wade. This design uses 43:10 instead of 37:11.

Source Thingiverse  :  http://www.thingiverse.com/thing:6713
Status Obsolete
License The GNU General Public License v2
Development Type Part
Categories Extruder
Goals Improvement Maintainability
Tags
Project/Vendor RepRap
Registered 7 years ago by garyhodgson
Updated 7 years ago
Author Greg Frost
Gear Ratio 43:10

Are you sure you wish to delete development 32005?