Number Six's Extruder Hot-end v1

Title Number Six's Extruder Hot-end v1

"I've been trying to come up with an extruder 'hot-end' design that doesn't use the expensive PEEK material that is in common use in other designs. My initial thoughts have been to use a salvaged heat-sink, clamping the feed shaft from the hot-end heater, and using a small fan to cool the heat-sink."

Source Blog  :
Status Obsolete
License License Unknown
Development Type Part
Categories Hot-End
Goals Economy Reproducability
Project/Vendor RepRap
Registered 7 years ago by garyhodgson
Updated 7 years ago
Author NumberSix

Are you sure you wish to delete development 56002?