Developments where status is Obsolete

Title Description Source Status
Accessible Wade's Extruder This is an extruder based strongly on the wades from the Prusa git repo. It has several features over the standard wade: + Accessible hobbing + The motor can be removed without removing the large gear. + Slightly higher gear ratio than standard wade. This design uses 43:10 instead of 37:11. Thingiverse Obsolete
Number Six's Extruder Hot-end v1 "I've been trying to come up with an extruder 'hot-end' design that doesn't use the expensive PEEK material that is in common use in other designs. My initial thoughts have been to use a salvaged heat-sink, clamping the feed shaft from the hot-end heater, and using a small fan to cool the he... Blog Obsolete
1 - 2 / 2 First, Previous, Next, Last